L5980 datasheet(7/37 Pages) STMICROELECTRONICS

7 / 37 page

Functional description

L5980

7/37

Functional description

The L5980 is based on a “voltage mode”, constant frequency control. The output voltage

VOUT is sensed by the feedback pin (FB) compared to an internal reference (0.6 V) providing

an error signal that, compared to a fixed frequency sawtooth, controls the on and off time of

the power switch.

The main internal blocks are shown in the block diagram in Figure 3. They are:

A fully integrated oscillator that provides sawtooth to modulate the duty cycle and the

synchronization signal. Its switching frequency can be adjusted by and external

resistor. The voltage and frequency feed forward are implemented.

The soft-start circuitry to limit inrush current during the start up phase.

The voltage mode error amplifier

The pulse width modulator and the relative logic circuitry necessary to drive the internal

power switch.

The high-side driver for embedded p-channel power MOSFET switch.

The peak current limit sensing block, to handle over load and short circuit conditions.

A voltage regulator and internal reference. It supplies internal circuitry and provides a

fixed internal reference.

A voltage monitor circuitry (UVLO) that checks the input and internal voltages.

A thermal shutdown block, to prevent thermal run away.

Figure 3.

Block diagram

L5980 데이터시트(PDF) 7 Page - STMicroelectronics