| 전자부품 데이터시트 검색엔진 |
|
M306H2FCFP 데이터시트(PDF) 39 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
M306H2FCFP 데이터시트(HTML) 39 Page - Renesas Technology Corp |
|
39 / 251 page ![]() 38 Rev. 1.0 SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER MITSUBISHI MICROCOMPUTERS M306H2FCFP 2.5.7 Power control The following is a description of the three available power control modes: Modes Power control is available in three modes. (a) Normal operation mode • High-speed mode Divide-by-1 frequency of the main clock becomes the BCLK. The CPU operates with the internal clock selected. Each peripheral function operates according to its assigned clock. • Medium-speed mode Divide-by-2, divide-by-4, divide-by-8, or divide-by-16 frequency of the main clock becomes the BCLK. The CPU operates according to the internal clock selected. Each peripheral function operates according to its assigned clock. • Low-speed mode fC becomes the BCLK. The CPU operates according to the fc clock. The fc clock is supplied by the secondary clock. Each peripheral function operates according to its assigned clock. • Low power dissipation mode The main clock operating in low-speed mode is stopped. The CPU operates according to the fC clock. The fc clock is supplied by the secondary clock. The only peripheral functions that operate are those with the sub-clock selected as the count source. When in single-chip mode, the device can be operated with a low supply voltage (VCC = 3.0 V) only during low power dissipation mode. Before entering or exiting low power dissipation mode, always make sure the supply voltage VCC is 5 V. Note: When operating with a low supply voltage, be aware that only the CPU, ROM, RAM, input/ output ports, timers (timers A and B), and the interrupt control circuit can be used. All other internal resources (e.g., data slicer, DMAC, A/D, and D/A) cannot be used. (b) Wait mode The CPU operation is stopped. The oscillators do not stop. (c) Stop mode The main clock and the sub-clock oscillators stop. The CPU and all built-in peripheral functions stop. This mode, among the three modes listed here, is the most effective in decreasing power consumption. Figure 2.5.5 is the state transition diagram of the above modes. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |