H8S2245 datasheet(164/818 Pages) RENESAS

164 / 818 page

Section 5 Interrupt Controller

Rev.3.00 Mar. 26, 2007 Page 122 of 772

REJ09B0355-0300

[1] If an interrupt source occurs when the corresponding interrupt enable bit is set to 1, an

interrupt request is sent to the interrupt controller.

[2] When interrupt requests are sent to the interrupt controller, a control level 1 interrupt,

according to the control level set in ICR, has priority for selection, and other interrupt requests

are held pending. If a number of interrupt requests with the same control level setting are

generated at the same time, the interrupt request with the highest priority according to the

priority system shown in table 5.4 is selected.

[3] The I bit is then referenced. If the I bit is cleared to 0, it is not affected by the UI bit.

An interrupt request set to interrupt control level 0 is accepted when the I bit is cleared to 0. If

the I bit is set to 1, only an NMI interrupt is accepted, and other interrupt requests are held

pending.

An interrupt request set to interrupt control level 1 has priority over an interrupt request set to

interrupt control level 0, and is accepted if the I bit is cleared to 0, or if the I bits is set to 1 and

the UI bit is cleared to 0.

When both the I bit and the UI bit are set to 1, only an NMI interrupt is accepted, and other

interrupt requests are held pending.

[4] When an interrupt request is accepted, interrupt exception handling starts after execution of the

current instruction has been completed.

[5] The PC and CCR are saved to the stack area by interrupt exception handling. The PC saved on

the stack shows the address of the first instruction to be executed after returning from the

interrupt handling routine.

[6] Next, the I and UI bits in CCR are set to 1. This masks all interrupts except NMI.

[7] A vector address is generated for the accepted interrupt, and execution of the interrupt

handling routine starts at the address indicated by the contents of that vector address.

H8S2245 데이터시트(PDF) 164 Page - Renesas Technology Corp