H8S2245 datasheet(190/818 Pages) RENESAS

190 / 818 page

Section 6 Bus Controller

Rev.3.00 Mar. 26, 2007 Page 148 of 772

REJ09B0355-0300

6.3.4

Advanced Mode

The initial state of each area is basic bus interface, 3-state access space. The initial bus width is

selected according to the operating mode. The bus specifications described here cover basic items

only, and the sections on each memory interface should be referred to for further details.

Area 0

Area 0 includes on-chip ROM, and in ROM-disabled expansion mode, all of area 0 is external

space. In ROM-enabled expansion mode, the space excluding on-chip ROM is external space.

When area 0 external space is accessed, the

CS0 signal can be output.

Either basic bus interface or burst ROM interface can be selected for area 0.

The size of area 0 is switched between 128 kbytes and 2 Mbytes according to the state of the ASS

bit.

Areas 1 to 6

In external expansion mode, all of area 1 to 6 is external space.

When area 1 to 3 external space is accessed, the

CS1 and CS3 pin signals respectively can be

output.

Only the basic bus interface can be used for areas 1 and 6.

The size of areas 1 to 6 is switched between 128 kbytes and 2 Mbytes according to the state of the

ASS bit.

Area 7

Area 7 includes the on-chip RAM and internal I/O registers. In external expansion mode, the space

excluding the on-chip RAM and internal I/O registers is external space. The on-chip RAM is

enabled when the RAME bit in the system control register (SYSCR) is set to 1; when the RAME

bit is cleared to 0, the on-chip RAM is disabled and the corresponding space becomes external

space.

Only the basic bus interface can be used for the area 7.

The size of area 7 is switched between 15 Mbytes and 2 Mbytes according to the state of the ASS

bit.

H8S2245 데이터시트(PDF) 190 Page - Renesas Technology Corp