H8S2245 datasheet(309/818 Pages) RENESAS

309 / 818 page

Section 8 I/O Ports

Rev.3.00 Mar. 26, 2007 Page 267 of 772

REJ09B0355-0300

• Modes 3 and 7

Setting a PEDDR bit to 1 makes the corresponding port E pin an output port, while clearing the

bit to 0 makes the pin an input port.

Note:

Modes 3 and 7 cannot be used in the H8S/2240.

Port E Data Register (PEDR)

PE7DR

R/W

PE6DR

R/W

PE5DR

R/W

PE4DR

R/W

PE3DR

R/W

PE0DR

R/W

PE2DR

R/W

PE1DR

R/W

Bit

Initial value

R/W

PEDR is an 8-bit readable/writable register that stores output data for the port E pins (PE

7 to PE0).

PEDR is initialized to H'00 by a power-on reset, and in hardware standby mode. It retains its prior

state after a manual reset, and in software standby mode.

Port E Register (PORTE)

PE7

—*

PE6

—*

PE5

—*

PE4

—*

PE3

—*

PE0

—*

PE2

—*

PE1

—*

Bit

Initial value

R/W

Note: * Determined by state of pins PE7 to PE0.

PORTE is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of

output data for the port E pins (PE

7 to PE0) must always be performed on PEDR.

If a port E read is performed while PEDDR bits are set to 1, the PEDR values are read. If a port E

read is performed while PEDDR bits are cleared to 0, the pin states are read.

After a power-on reset and in hardware standby mode, PORTE contents are determined by the pin

states, as PEDDR and PEDR are initialized. PORTE retains its prior state after a manual reset, and

in software standby mode.

H8S2245 데이터시트(PDF) 309 Page - Renesas Technology Corp

H8S2245 데이터시트(HTML) 309 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL