SPC5702BECLU datasheet(70/98 Pages) FREESCALE

70 / 98 page

MPC560xS Microcontroller Data Sheet Data Sheet, Rev. 1

Preliminary—Subject to Change Without Notice

Electrical Characteristics

Freescale Semiconductor

Figure 17. Spectral Representation of Input Signal

Calling f0 the bandwidth of the source signal (and as a consequence the cut-off frequency of the anti-aliasing filter, fF),

according to the Nyquist theorem the conversion rate fC must be at least 2f0; it means that the constant time of the filter is greater

than or at least equal to twice the conversion period (TC). Again the conversion period TC is longer than the sampling time TS,

which is just a portion of it, even when fixed channel continuous conversion mode is selected (fastest conversion rate at a

specific channel): in conclusion it is evident that the time constant of the filter RFCF is definitively much higher than the

sampling time TS, so the charge level on CS cannot be modified by the analog signal source during the time in which the

sampling switch is closed.

The considerations above lead to impose new constraints on the external circuit, to reduce the accuracy error due to the voltage

drop on CS; from the two charge balance equations above, it is simple to derive Equation 12 between the ideal and real sampled

voltage on CS:

Eqn. 12

From this formula, in the worst case (when VA is maximum, that is for instance 5V), assuming to accept a maximum error of

half a count, a constraint is evident on CF value:

Eqn. 13

3.14.2

ADC Electrical Characteristics

Analog Source Bandwidth (VA)

Sampled Signal Spectrum (fC = conversion Rate)

Anti-Aliasing Filter (fF = RC Filter pole)

2 f0 ≤ fC (Nyquist)

fF = f0 (Anti-aliasing Filtering Condition)

TC ≤ 2 RFCF (Conversion Rate vs. Filter Pole)

Noise

VA2

------------

CP1 CP2

+CF

CP1 CP2

+CF CS

--------------------------------------------------------

CF 2048 CS

•

SPC5702BECLU 데이터시트(PDF) 70 Page - Freescale Semiconductor, Inc