LPC2292 datasheet(21/53 Pages) NXP

21 / 53 page

LPC2292_2294_7

Product data sheet

Rev. 7 — 4 December 2008

21 of 53

NXP Semiconductors

LPC2292/LPC2294

16/32-bit ARM microcontrollers with external memory interface

capability to both receive and send information (such as memory). Transmitters and/or

receivers can operate in either master or slave mode, depending on whether the chip has

to initiate a data transfer or is only addressed. The I2C-bus is a multi-master bus, it can be

controlled by more than one bus master connected to it.

The I2C-bus implemented in LPC2292/LPC2294 supports bit rate up to 400 kbit/s (Fast

I2C-bus).

6.12.1 Features

• Compliant with standard I2C-bus interface.

• Easy to conﬁgure as master, slave, or master/slave.

• Programmable clocks allow versatile rate control.

• Bidirectional data transfer between masters and slaves.

• Multi-master bus (no central master).

• Arbitration between simultaneously transmitting masters without corruption of serial

data on the bus.

• Serial clock synchronization allows devices with different bit rates to communicate via

one serial bus.

• Serial clock synchronization can be used as a handshake mechanism to suspend and

resume serial transfer.

• The I2C-bus may be used for test and diagnostic purposes.

6.13 SPI serial I/O controller

The LPC2292/LPC2294 each contain two SPIs. The SPI is a full duplex serial interface,

designed to be able to handle multiple masters and slaves connected to a given bus. Only

a single master and a single slave can communicate on the interface during a given data

transfer. During a data transfer the master always sends a byte of data to the slave, and

the slave always sends a byte of data to the master.

6.13.1 Features

• Compliant with Serial Peripheral Interface (SPI) speciﬁcation.

• Synchronous, Serial, Full Duplex communication.

• Combined SPI master and slave.

• Maximum data bit rate of 1

⁄

8 of the input clock rate.

6.13.2 Features available in LPC2292/LPC2294/01 only

• Eight to 16 bits per frame.

• When the SPI interface is used in Master mode, the SSELn pin is not needed (can be

used for a different function).

LPC2292 데이터시트(PDF) 21 Page - NXP Semiconductors

LPC2292 데이터시트(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

데이터시트 다운로드

링크 URL