22

3633E–DFLASH–10/07

AT26DF321

The complete one byte of data must be clocked into the device before the CS pin is deasserted;

otherwise, the device will abort the operation, the state of the SPRL bit will not change, no

potential Global Protect or Unprotect will be performed, and the WEL bit in the Status Register

will be reset back to the logical “0” state.

If the WP pin is asserted, then the SPRL bit can only be set to a logical “1”. If an attempt is made

to reset the SPRL bit to a logical “0” while the WP pin is asserted, then the Write Status Register

command will be ignored, and the WEL bit in the Status Register will be reset back to the logical

“0” state. In order to reset the SPRL bit to a logical “0”, the WP pin must be deasserted.

Figure 10-2. Write Status Register

11. Other Commands and Functions

11.1

Read Manufacturer and Device ID

Identification information can be read from the device to enable systems to electronically query

and identify the device while it is in system. The identification method and the command opcode

comply with the JEDEC standard for “Manufacturer and Device ID Read Methodology for SPI

Compatible Serial Interface Memory Devices”. The type of information that can be read from the

device includes the JEDEC defined Manufacturer ID, the vendor specific Device ID, and the ven-

dor specific Extended Device Information.

To read the identification information, the CS pin must first be asserted and the opcode of 9Fh

must be clocked into the device. After the opcode has been clocked in, the device will begin out-

putting the identification data on the SO pin during the subsequent clock cycles. The first byte

that will be output will be the Manufacturer ID followed by two bytes of Device ID information.

The fourth byte output will be the Extended Device Information String Length, which will be 00h

indicating that no Extended Device Information follows. After the Extended Device Information

String Length byte is output, the SO pin will go into a high-impedance state; therefore, additional

clock cycles will have no affect on the SO pin and no data will be output. As indicated in the

JEDEC standard, reading the Extended Device Information String Length and any subsequent

data is optional.

Deasserting the CS pin will terminate the Manufacturer and Device ID read operation and put

the SO pin into a high-impedance state. The CS pin can be deasserted at any time and does not

require that a full byte of data be read.

Table 10-2.

Write Status Register Format

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

SPRL

X

Global Protect/Unprotect

X

X

SCK

CS

SI

SO

MSB

23

1

0

0000000

67

5

410 11

9

8

14 15

13

12

OPCODE

MSB

1D

X

D

D

D

D

X

X

STATUS REGISTER IN

HIGH-IMPEDANCE