AT89C5131A-RDTUM datasheet(126/188 Pages) ATMEL

126 / 188 page

126

4337K–USB–04/08

AT89C5130A/31A-M

21.4.1

Bulk/Interrupt OUT Transactions in Standard Mode

Figure 21-7. Bulk/Interrupt OUT transactions in Standard Mode

An endpoint will be first enabled and configured before being able to receive Bulk or Interrupt

packets.

When a valid OUT packet is received on an endpoint, the RXOUTB0 bit is set by the USB con-

troller. This triggers an interrupt if enabled. The firmware has to select the corresponding

endpoint, store the number of data bytes by reading the UBYCTLX and UBYCTHX registers. If

the received packet is a ZLP (Zero Length Packet), the UBYCTLX and UBYCTHX register val-

ues are equal to 0 and no data has to be read.

When all the endpoint FIFO bytes have been read, the firmware will clear the RXOUTB0 bit to

allow the USB controller to accept the next OUT packet on this endpoint. Until the RXOUTB0 bit

has been cleared by the firmware, the USB controller will answer a NAK handshake for each

OUT requests.

If the Host sends more bytes than supported by the endpoint FIFO, the overflow data won’t be

stored, but the USB controller will consider that the packet is valid if the CRC is correct and the

endpoint byte counter contains the number of bytes sent by the Host.

OUT

DATA0 (n bytes)

ACK

HOST

UFI

C51

Endpoint FIFO read byte 1

OUT

DATA1

NAK

RXOUTB0

Endpoint FIFO read byte 2

Endpoint FIFO read byte n

Clear RXOUTB0

OUT

DATA1

NAK

OUT

DATA1

ACK

RXOUTB0

Endpoint FIFO read byte 1

AT89C5131A-RDTUM 데이터시트(PDF) 126 Page - ATMEL Corporation

AT89C5131A-RDTUM 데이터시트(HTML) 126 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL