CMS3216LAH datasheet(11/46 Pages) FIDELIX

11 / 46 page

Rev0.2, Aug. 2006

CMS3216LAx-75Ex

EXTENDED MODE REGISTER

The Extended Mode Register controls additional functions such

as Partial Array Self Refresh (PASR), and Output Drive

Strength.The Extended Mode Register is programmed via the

Mode Register Set command (BS=1) and retains the stored

information until it is programmed again or the device loses

power. The Extended Mode Register must be programmed with

M8 through M10 set to “0”. The Extended Mode Register must

be loaded when all banks are idle and no bursts are in progress,

and the controller must wait the specified time initiating any

subsequent operation. Violating either of these requirements

results in unspecified operation.

AUTO TEMPERATURE COMPENSATED SELF REFRESH

Every cell in the DRAM requires refreshing due to the capacitor

losing its charge over time. The refresh rate is dependent on

temperature. At higher temperatures a capacitor loses charge

quicker than at lower temperatures, requiring the cells to be

refreshed more often. In order to save power consumption,

according to the temperature, Mobile-SDRAM includes the

internal temperature sensor and control units to control the self

refresh cycle automatically.

PARTIAL ARRAY SELF REFRESH

The Partial Array Self Refresh (PASR) feature allows the

controller to select the amount of memory that will be refreshed

during SELF REFRESH. The refresh options are all banks

(banks 0, 1); one bank (bank 0 or 1 by M7). WRITE and READ

commands occur to any bank selected during standard

operation, but only the selected banks in PASR will be

refreshed during SELF REFRESH. The data in banks 1 will be

lost when the one bank option with M7=0 is used. Similarly the

data will be lost in bank 0 when the one bank option with M7=1

is used down

Driver Strength Control

The driver strength feature allows one to reduce the drive

strength of the I/O’s on the device during low frequency

operation. This allows systems to reduce the noise associated

with the I/O’s switching.

Table 4. Extended Mode Register Definition

Bank

Up/Down

All must be set to ‘0’

Driver Strength

EM6-

EM5-

EM4-

EM3-

PASR

EM2-

EM1-

EM9-

EM8-

EM7-

EM0-

EM10-

A10

EM11-

CMS3216LAH 데이터시트(PDF) 11 Page - FIDELIX

CMS3216LAH 데이터시트(HTML) 11 Page - FIDELIX

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

데이터시트 다운로드

링크 URL