AT90USB646 datasheet(48/459 Pages) ATMEL

48 / 459 page

7593H–AVR–11/08

ATmega32U6/AT90USB64/128

“0011”, giving a division factor of 8 at start up. This feature should be used if the selected clock

source has a higher frequency than the maximum frequency of the device at the present operat-

ing conditions. Note that any value can be written to the CLKPS bits regardless of the CKDIV8

Fuse setting. The Application software must ensure that a sufficient division factor is chosen if

the selected clock source has a higher frequency than the maximum frequency of the device at

the present operating conditions. The device is shipped with the CKDIV8 Fuse programmed.

Table 6-10.

Clock Prescaler Select

6.10

PLL

The PLL is used to generate internal high frequency (48 MHz) clock for USB interface, the PLL

input is generated from an external low-frequency (the crystal oscillator or external clock input

pin from XTAL1). The internal RC Oscillator can not be used for USB operations.

6.10.1

Internal PLL for USB interface

The internal PLL in ATmega32U6/AT90USB64/128 generates a clock frequency that is 24x mul-

tiplied from nominally 2 MHz input. The source of the 2 MHz PLL input clock is the output of the

internal PLL clock prescaler that generates the 2 MHz (See Section 6.10.2 for PLL interface).

CLKPS3

CLKPS2

CLKPS1

CLKPS0

Clock Division Factor

128

256

Reserved

AT90USB646 데이터시트(PDF) 48 Page - ATMEL Corporation