THE CONNOR-WINFIELD CORP.

2111 COMPREHENSIVE DRIVE.

AURORA, IL 60505.

FAX (630) 851-5040.

PHONE (630) 851-4722.

PRODUCT

DA TA

SHEET

Specifications subject to change without notice.

DATASHEET #:

REV:

DATE:

PAGE

OF

Copyright 2001 Connor-Winfield all rights reserved.

a

CRYSTAL CONTROLLED OSCILLATORS

2

2

Cx087

00

11/11/05

www.conwin.com

ENVIRONMENTAL CHARACTERISTICS

Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1minut e

transition.

Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20

seconds.

SOLDERING

Pin Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage.

Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C

±5°C for 20 Seconds.

MECHANICAL CHARACTERISTICS

Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15minute c ycles 12 times each

perpendicular axis.

Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction.

Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C.

CONTROL VOLTAGE

4.5

20K

POT

Notes:

1) Initial calibration @ 25

°C, Vc = 2.50V at time of shipment.

2) Frequency vs. temperature stability, -20 to 70°C absolute.

3) Frequency stability per 5% change in supply voltage.

4) Frequency stability per 5% change in load

5) Inclusive of calibration, operating temperature range, supply voltage change, load change, shock

and vibration and aging over 20 years.

6) Measured @ 25

°C, within 5 minutes, the unit will be within +/-0.5ppm of nominal.

7) 24 hours off then 60 minutes on at a constant temper ature and voltage.

8) Referenced to Fo @ 25

°C, Positive Transfer Characteristic.

9) Supply voltage at 5.00 Vdc.