5

LTC1606

1606fa

Note 1: Absolute Maximum Ratings are those values beyond which the life

of a device may be impaired.

Note 2: All voltage values are with respect to ground with DGND, AGND1

and AGND2 wired together (unless otherwise noted).

without latch-up.

Note 4: When these pin voltages are taken below ground, they will be

clamped by internal diodes. This product can handle input currents of

specified.

with respect to ground.

Note 7: Integral nonlinearity is defined as the deviation of a code from a

straight line passing through the actual end points of the transfer curve.

The deviation is measured from the center of the quantization band.

Note 8: Bipolar offset is the offset voltage measured from – 0.5 LSB when

the output code flickers between 0000 0000 0000 0000 and 1111 1111

1111 1111.

Note 9: Guaranteed by design, not subject to test.

Note 10: Recommended operating conditions.

Note 11: With CS low the falling R/C edge starts a conversion. If R/C

returns high at a critical point during the conversion, it can create errors.

For best results, ensure that R/C returns high within 1

µs after the start of

the conversion.

Note 12: As measured with fixed resistors shown in Figure 4. Adjustable to

zero with external potentiometer.

Note 13: Full-scale error is the worst-case of –FS or +FS untrimmed

deviation from ideal first and last code transitions, divided by the transition

voltage (not divided by the full-scale range) and includes the effect of

offset error.

Note 14: All specifications in dB are referred to a full-scale

±10V input.

Note 15: Full-power bandwidth is defined as full-scale input frequency at

which a signal-to-(noise + distortion) degrades to 60dB or 10 bits of

accuracy.

Note 16: Recovers to specified performance after (2 • FS) input

overvoltage.

LTC1606/LTC1606A

SYMBOL

PARAMETER

CONDITIONS

MIN

TYP

MAX

UNITS

Positive Supply Voltage

(Notes 9, 10)

4.75

5.25

V

Positive Supply Current

●

15

20

mA

Power Dissipation

●

75

100

mW

The