80C52 datasheet(36/54 Pages) TEMIC

36 / 54 page

Rev. B - Jan. 25, 1999

Preliminary

TS80C52X2

Figure 11. Set-Up Modes Configuration

8.3.3 Programming Algorithm

The Improved Quick Pulse algorithm is based on the Quick Pulse algorithm and decreases the number of pulses

applied during byte programming from 25 to 1.

To program the TS87C52X2 the following sequence must be exercised:

Step 1: Activate the combination of control signals.

Step 2: Input the valid address on the address lines.

Step 3: Input the appropriate data on the data lines.

Step 4: Raise EA/VPP from VCC to VPP (typical 12.75V).

Step 5: Pulse ALE/PROG once.

Step 6: Lower EA/VPP from VPP to VCC

Repeat step 2 through 6 changing the address and data for the entire array or until the end of the object file is

reached (See Figure 12.).

8.3.4 Verify algorithm

Code array verify must be done after each byte or block of bytes is programmed. In either case, a complete verify

of the programmed array will ensure reliable programming of the TS87C52X2.

P 2.7 is used to enable data output.

To verify the TS87C52X2 code the following sequence must be exercised:

Step 1: Activate the combination of program and control signals.

Step 2: Input the valid address on the address lines.

Step 3: Read data on the data lines.

Repeat step 2 through 3 changing the address for the entire array verification (See Figure 12.)

+5V

VCC

P0.0-P0.7

P1.0-P1.7

P2.0-P2.4

VSS

GND

D0-D7

A0-A7

A8-A12

RST

EA/VPP

ALE/PROG

PSEN

P2.6

P2.7

P3.3

P3.7

P3.6

XTAL1

4 to 6 MHz

CONTROL

SIGNALS*

PROGRAM

SIGNALS*

* See Table 31. for proper value on these inputs

80C52 데이터시트(PDF) 36 Page - TEMIC Semiconductors

80C52 데이터시트(HTML) 36 Page - TEMIC Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

데이터시트 다운로드

링크 URL