PCI2050 datasheet(39/81 Pages) TI

39 / 81 page

3–15

3.16.2 Transaction Forwarding Control

The PCI 2050 will stop forwarding I/O and memory transactions if bit 5 of the chip control register (offset 40h, see

Section 5.1) is set to 1 and GPIO3 is driven high. The bridge will complete all queued posted writes and delayed

requests, but delayed completions will not be returned until GPIO3 is driven low and transaction forwarding is

resumed. The bridge will continue to accept configuration cycles in this mode. This feature is not available when in

compact PCI hot-swap mode because GPIO3 iis used as the HS_SWITCH input in this mode.

3.17 PCI Power Management

The

PCI Power Management Specification establishes the infrastructure required to let the operating system control

the power of PCI functions. This is done by defining a standard PCI interface and operations to manage the power

of PCI functions on the bus. The PCI bus and the PCI functions can be assigned one of four software visible power

management states, which result in varying levels of power savings.

The four power management states of PCI functions are D0 — fully on state, D1 and D2 — intermediate states, and

D3 — off state. Similarly, bus power states of the PCI bus are B0–B3. The bus power states B0–B3 are derived from

the device power state of the originating PCI2050 device.

For the operating system to manage the device power states on the PCI bus, the PCI function supports four power

management operations:

•

Capabilities reporting

•

Power status reporting

•

Setting the power state

•

System wake-up

The operating system identifies the capabilities of the PCI function by traversing the new capabilities list. The

presence of the new capabilities list is indicated by a bit in the status register (offset 06h, see Section 4.4) which

provides access to the capabilities list.

3.17.1 Behavior in Low Power States

The PCI2050 supports D0, D1, D2, and D3hot power states when in TI mode. The PCI2050 only supports D0 and

D3 power states when in Intel mode. The PCI2050 is fully functional only in D0 state. In the lower power states, the

bridge does not accept any memory or I/O transactions. These transactions are aborted by the master. The bridge

accepts type 0 configuration cycles in all power states except D3cold. The bridge also accepts type 1 configuration

cycles but does not pass these cycles to the secondary bus in any of the lower power states. Type 1 configuration

writes are discarded and reads return all 1s. All error reporting is done in the low power states. When in D2 and D3hot

states, the bridge turns off all secondary clocks for further power savings.

When going from D3hot to D0, an internal reset is generated. This reset initializes all PCI configuration registers to

their default values. All TI specific registers (40h – FFh) are not reset. Power management registers are also not reset.

PCI2050 데이터시트(PDF) 39 Page - Texas Instruments