TMS320F241FN datasheet(29/116 Pages) TI

29 / 116 page

TMS320F243, TMS320F241

DSP CONTROLLERS

SPRS064B – DECEMBER 1997 – REVISED FEBRUARY 1999

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251–1443

interrupt request structure

At the lower level of the hierarchy, the peripheral interrupt requests (PIRQs) from several peripherals to the

interrupt controller are ORed together to generate a request to the CPU. There is an interrupt flag bit and

an interrupt enable bit located in the peripheral for each event that can cause a peripheral interrupt request.

There is also one PIRQ for each event. If an interrupt-causing event occurs in a peripheral, and the

corresponding interrupt enable bit is set, the interrupt request from the peripheral to the interrupt controller

is asserted. This interrupt request simply reflects the status of the peripheral’s interrupt flag gated with the

interrupt enable bit. When the interrupt flag is cleared, the interrupt request is cleared. Some peripherals

have the capability to make either a high-priority or a low-priority interrupt request. If a peripheral has this

capability, the value of its interrupt priority bit is transmitted to the interrupt controller. The interrupt request

continues to be asserted until it is either automatically cleared by an interrupt acknowledge or cleared by

software.

At the upper level of the hierarchy, the ORed PIRQs generate interrupt (INT) requests to the CPU. The

request to the ’24x CPU is a low-going pulse of 2 CPU clock cycles. The Peripheral Interrupt Expansion

(PIE) controller generates an INT pulse when any of the PIRQs controlling that INT go active. If any of the

PIRQs capable of asserting that CPU interrupt request are still active in the cycle following an interrupt

acknowledge for that INT, another INT pulse is generated (an interrupt acknowledge clears the

highest-priority pending PIRQ). Which CPU interrupt requests get asserted by which peripheral interrupt

requests, and the relative priority of each peripheral interrupt request, is defined in the interrupt controller

and is not part of any of the peripherals. This is shown in Table 10.

TMS320F241FN 데이터시트(PDF) 29 Page - Texas Instruments