SPT5420SIM datasheet(5/8 Pages) CADEKA

5 / 8 page

6/26/01

SPT5420

VOLTAGE REFERENCES AND

ANALOG GROUND INPUTS

Three VREFTXX and three VREFBXX inputs set the output

range of the three corresponding groups of DACs

(0 and 1; 2 through 5; 6 and 7). Four RGNDXX inputs set

the output offset voltage of the four corresponding groups

of DACs (0 and 1; 2 and 3; 4 and 5; 6 and 7). The formula

for output swing and offset is presented in the “Analog

Outputs” section below.

DAC ADDRESSING AND LATCHING

Each DAC has an input latch which receives data from the

data bus, and a DAC latch which receives data from the

input latch. The analog output of each DAC corresponds

to the data in its DAC latch. One of the eight input latches

is addressed by the address lines A(2:0) according to

Table I. While CS and WR are low, the addressed input

latch is transparent and the seven other input latches are

latched. Bringing CS or WR high latches data into the ad-

dressed input latch. While LDAC is low, all eight DAC

latches are transparent. Bringing LDAC high latches data

into the DAC latches. While CS, WR and LDAC are low, both

latches are transparent and input data is transferred

directly to the selected DAC. While CLR is low, all DAC out-

puts are set to their corresponding RGNDXX. Bringing CLR

high returns each DAC’s output to the voltage correspond-

ing to the data in each DAC latch.

Table II summarizes this information, and figures 1a and

1b should be referenced for timing limitations.

POWER SUPPLY SEQUENCING

The sequence in which VDD, VSS and VCC come up is not

critical. The reference inputs, VREFTXX and VREFBXX, must

come on only after VDD and VSS have been established.

However, they may be turned on prior to VCC. The digital

inputs must be driven only after VDD, VSS and VCC have

been established. Reverse the power-on sequence for

power-down.

ANALOG OUTPUTS VS DIGITAL INPUT

CODE

The output voltage range is equal to twice the difference

between VREFTXX and VREFBXX. The output voltage is

given by:

VOUT = 2 X (VREFB +[VREFT – VREFB] X

INPUT CODE

8192

) – VRGND

CODE = 0 – 8191

Table I – DAC Addressing

Addressed Input

Latch DAC#

000

001

010

011

100

101

110

111

Table II – Control Logic Table

LDAC

CLR

Input Latch DAC Latch

transparent1

latched

transparent

latched

DAC outputs at RGNDXX

Note:

1. Only the input latch addressed by A(2:0) is transparent.

The other input latches are latched.

SPT5420SIM 데이터시트(PDF) 5 Page - Cadeka Microcircuits LLC.

SPT5420SIM 데이터시트(HTML) 5 Page - Cadeka Microcircuits LLC.

Html Pages

1 2 3 4 5 6 7 8

데이터시트 다운로드

링크 URL