• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macomtech.com for additional data sheets and product information.

M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

changes to the product(s) or information contained herein without notice.

2

Voltage Variable Attenuator

824 - 960 MHz

Rev. V3

MAATCC0013

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.

Commitment to produce in volume is not guaranteed.

Parameter

Test Conditions

Units

Min

Typ

Max

Insertion Loss

dB

—

1.7

2.1

VSWR

Ratio

—

1.7

2.2

Attenuation Flatness vs.

Frequency

0 - 10 dB

0 - 20 dB

0 - 30 dB

dB

dB

dB

—

—

—

1.3

1.3

2.5

—

—

—

Switching Speed

50% control to 90%/10% RF

usec

—

7.0

—

Input IP3

Two Tones 900 MHz, 905 MHz, +5 dBm

dBm

—

40

—

Input IP2

Two Tones 900 MHz, 905 MHz, +5 dBm

dBm

—

34

—

Attenuation

dB

25

28

—

Recommended PCB Configuration

5

Absolute Maximum Ratings

3,4

Parameter

Absolute Maximum

Max Input Power

+27 dBm

Operating Voltage

+5 V

Operating Temperature

-40°C to +85°C

Storage Temperature

-65°C to +125°C

3.

Exceeding any one or combination of these limits may

cause permanent damage to this device.

4.

M/A-COM does not recommend sustained operation near

these survivability limits.

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

GMIC

Circuits

are

sensitive

to

electrostatic

discharge (ESD) and can be damaged by static

electricity. Proper ESD control techniques should

be used when handling these devices.

5.

Circuit Material = FR-406, 0.031 inches thick.

Line Width = 0.025 inches, Line Spacing = 0.0056

inches.