MEGAWIN

MPC89x51A Data Sheet

13

Functional Description

TIMERS/COUNTERS

MPC89x51A has three 16-bits timers, and they are named T0, T1 and T2.Each of them can also

be used as a general event counter, which counts the transition from 1 to 0.

While T0/T1/T2 is used as “timer” function, the time unit that used to measure the timer is

machine cycle. A machine cycle equals 12 or 6 oscillator periods, and depends on 12T mode or

6T mode that the user configured this device.

While T0/T1/T2 is used as “1-0 event counter” function, the counting event is the “high-to-low

transition” of primitive pin T0/T1/T2. In this mode, the device periodically samples the status of

pin T0/T1/T2 once for each machine cycle. Whenever the sampled result turns from 1 to 0, the

device will count once on the counter.

Becarefully, this kind of implementation for the counter

requires the high-duty or low-duty from pin T0/T1/T2 and must not too short compared to a

machine cycle.

There are two SFR designed to configure timers T0 and T1. They are TMOD, and TCON.

There are extra two SFR designed to configure timer T2. They are T2MOD, and T2CON.

SFR: TMOD

Bits-7

Bits-6

Bits-5

Bits-4

Bits-3

Bits-2

Bits-1

Bits-0

(for timer1 use)

(for timer0 use)

GATE

C//T

M1

M0

GATE

C//T

M1

M0

GATE: Gating control when set. If GATE=1, Timer/Counter x is enabled only while “/INTx” pin is high and

“TRx” control bits is set.

When cleared Timer x is enabled whenever “TRx” control bits is set.

C//T: Timer or Counter function selector. 0: =timer (Default), 1: =counter

{M1, M0}: mode select

{0, 0}: = 13-bits timer/counter for Timer0 and Timer1

{0, 1}: = 16-bits timer/counter for Timer0 and Timer1

{1, 0}: = 8-bits timer/counter with automatic reload for Timer0 and Timer1

{1, 1}: = for Timer0: = TL0 is 8-bits timer/counter, TH0 is locked into 8-bits timer

for Timer1:= Timer/Counter1 Stopped