ATmega16 datasheet(231/357 Pages) ATMEL

231 / 357 page

231

2466S–AVR–05/09

ATmega16(L)

The active states are:

•

Capture-DR: Data on the external pins are sampled into the Boundary-scan Chain.

•

Shift-DR: The Boundary-scan Chain is shifted by the TCK input.

•

Update-DR: Data from the Boundary-scan Chain is applied to the output latches. However,

the output latches are not connected to the pins.

AVR_RESET; $C

The AVR specific public JTAG instruction for forcing the AVR device into the Reset mode or

releasing the JTAG Reset source. The TAP controller is not reset by this instruction. The one bit

Reset Register is selected as Data Register. Note that the reset will be active as long as there is

a logic 'one' in the Reset Chain. The output from this chain is not latched.

The active states are:

•

Shift-DR: The Reset Register is shifted by the TCK input.

BYPASS; $F

Mandatory JTAG instruction selecting the Bypass Register for Data Register.

The active states are:

•

Capture-DR: Loads a logic “0” into the Bypass Register.

•

Shift-DR: The Bypass Register cell between TDI and TDO is shifted.

Boundary-scan

Related Register in I/O

Memory

MCU Control and

Status Register –

MCUCSR

The MCU Control and Status Register contains control bits for general MCU functions, and pro-

vides information on which reset source caused an MCU Reset.

• Bit 7 – JTD: JTAG Interface Disable

When this bit is zero, the JTAG interface is enabled if the JTAGEN Fuse is programmed. If this

bit is one, the JTAG interface is disabled. In order to avoid unintentional disabling or enabling of

the JTAG interface, a timed sequence must be followed when changing this bit: The application

software must write this bit to the desired value twice within four cycles to change its value.

If the JTAG interface is left unconnected to other JTAG circuitry, the JTD bit should be set to

one. The reason for this is to avoid static current at the TDO pin in the JTAG interface.

• Bit 4 – JTRF: JTAG Reset Flag

This bit is set if a reset is being caused by a logic one in the JTAG Reset Register selected by

the JTAG instruction AVR_RESET. This bit is reset by a Power-on Reset, or by writing a logic

zero to the flag.

Bit

765

432

JTD

ISC2

–JTRF

WDRF

BORF

EXTRF

PORF

MCUCSR

Read/Write

R/W

Initial Value

See Bit Description

ATmega16 데이터시트(PDF) 231 Page - ATMEL Corporation

ATmega16 데이터시트(HTML) 231 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL