ICS1893 datasheet(81/152 Pages) ICST

81 / 152 page

Chapter 8

Management Register Set

ICS1893 Rev C 6/6/00

June, 2000

ICS1893 - Release

8.7.2

Acknowledge (bit 5.14)

The ISO/IEC specification defines bit 5.14 as the Acknowledge bit. When this bit is a:

• Zero, it indicates that the remote link partner has not received the ICS1893 Link Control Word.

• One, it indicates to the ICS1893 / STA that the remote link partner has acknowledged reception of the

ICS1893 Link Control Word.

8.7.3

Remote Fault (bit 5.13)

The ISO/IEC specification defines bit 5.13 as the Remote Fault bit. This bit is set based on the Link Control

Word received from the remote link partner. When this bit is a logic:

• Zero, it indicates that the remote link partner detects a Link Fault.

• One, it indicates to the ICS1893 / STA that the remote link partner detects a Link Fault.

Note:

For more information about this bit, see Section 8.3.9, “Remote Fault (bit 1.4)”.

8.7.4

Technology Ability Field (bits 5.12:5)

The Technology Ability Field (TAF) bits (bits 5.12:5) determine the specific abilities that the remote link

partner is advertising. These bits are set based upon the Link Code Word received from the remote link

partner during the auto-negotiation process. The ISO/IEC specification defines the TAF technologies in

Annex 28B.

The ISO/IEC specification reserves bits 5.12:10 for future use. When each of these reserved bits is:

• Read by an STA, the ICS1893 returns a logic zero.

• Written to by an STA, the STA must use the default value specified in this data sheet.

ICS uses some reserved bits to invoke auxiliary functions. To ensure proper operation of the ICS1893, an

STA must maintain the default value of these bits. Therefore, ICS recommends that an STA always write

the default value of any reserved bits during all management register write operations.

8.7.5

Selector Field (bits 5.4:0)

The Selector Field bits indicate the technology or encoding that the remote link partner is using for the

Auto-Negotiation message. The ICS1893 supports only IEEE Std 802.3, represented by a value of 00001b

in bits 5.4:0. The ISO/IEC standard defines the Selector Field technologies in Annex 28A. Presently, the

IEEE standard defines the following two valid codes:

• 00001b (IEEE Std 802.3)

• 00010b (IEEE Std 802.9)

ICS1893 데이터시트(PDF) 81 Page - Integrated Circuit Systems