ATtiny167-ESSZ datasheet(233/282 Pages) ATMEL

부품명	ATtiny167-ESSZ

상세설명	8-bit Microcontroller with 8K/16K Bytes In-System Programmable Flash and LIN Controller

PDF	282 Pages

Scroll/Zoom	100%

제조업체	ATMEL [ATMEL Corporation]

홈페이지	http://www.atmel.com

Logo

233 / 282 page

233

7728D–AVR–07/09

ATtiny87/ATtiny167

G. Load Address High byte

Set XA1, XA0 to “0,0”. This enables address loading.

Set BS1 to “1”. This selects high address.

Set DATA = Address high byte (0x00 - 0xFF).

Give XTAL1 a positive pulse. This loads the address high byte.

H. Program Page

Give WR a negative pulse. This starts programming of the entire page of data.

RDY/BSY goes low.

Wait until RDY/BSY goes high (See Figure 21-3 for signal waveforms).

I. Repeat B through H until the entire Flash is programmed or until all data has been

programmed.

J. End Page Programming

1. Set XA1, XA0 to “1,0”. This enables command loading.

Set DATA to “0000 0000

b”. This is the command for No Operation.

Give XTAL1 a positive pulse. This loads the command, and the internal write signals

are reset.

Figure 21-2. Addressing the Flash Which is Organized in Pages

Note:

1. PCPAGE and PCWORD are listed in

PROGRAM MEMORY

WORD ADDRESS

WITHIN A PAGE

PAGE ADDRESS

WITHIN THE FLASH

INSTRUCTION WORD

PAGE

PCWORD[PAGEMSB:0]:

PAGEEND

PAGE

PCWORD

PCPAGE

PCMSB

PAGEMSB

PROGRAM COUNTER

ATtiny167-ESSZ 데이터시트(PDF) 233 Page - ATMEL Corporation