Flexible Port Configurations

The PEX 8609 supports a large number of port configurations

as shown in figure 1 below. Please refer to the PEX 8609

datasheet for more port configuration options.

Figure 1. PEX8609 Port Configurations

Hot-Plug for High Availability

Hot-Plug capability allows users to replace hardware modules

and perform maintenance without powering down the system.

The PEX 8609 Hot-Plug capability feature makes it suitable

for High Availability (HA) applications. If the PEX 8609 is

used in an application where one or more of its downstream

ports connect to PCI Express slots, each port’s Hot-Plug

Controller can be used to manage the Hot-Plug event of its

associated slot. Every port on the PEX 8609 is equipped with

a Hot-Plug control/status register to support Hot-Plug

capability through external logic via the I

Dual Cast

The PEX 8609 supports Dual Cast, a feature which allows for

the copying of data (e.g. packets) from one ingress port to two

egress ports allowing for higher performance in storage,

security, and mirroring applications.

Read Pacing

The Read Pacing feature allows users to throttle the amount of

read requests being made by downstream devices. In the case

where a downstream device requests several long reads back-

to-back, the Root Complex gets tied up in serving this

downstream port. If this port has a narrow link and is therefore

slow in receiving these read packets from the Root Complex,

then other downstream ports may become starved – thus,

impacting performance. The Read Pacing feature enhances

performances by allowing for the adequate servicing of all

downstream devices by intelligent handling of read requests.

SerDes Power and Signal Management

The PEX 8609 provides low power capability that is fully

compliant with the PCI Express power management

specification. In addition, the SerDes physical links can be

turned off when unused for even lower power. The PEX 8609

supports software control of the SerDes outputs to allow

optimization of power and signal strength in a system. The

PLX SerDes implementation supports four levels of power –

off, low, typical, and high. The SerDes block also supports

loop-back modes and advanced reporting of error

conditions, which enables efficient debug and management of

the entire system.

Port and Virtual Channel (VC) Arbitration

The PEX 8609 switch supports hardware fixed and Weighted

Round-Robin Ingress Port Arbitration. This allows fine tuning

of Quality of Service and efficient use of packet buffers for

better system performance. The PEX 8609 also supports WRR

VC arbitration scheme between the two virtual channels.

Applications

Suitable for fan-out, control plane applications, embedded

systems as well as intelligent I/O applications, PEX 8609

can be configured for a wide variety of form factors and

applications.

Fan-Out

The PEX 8609 switch, with its high port count and flexible

configurations, allows user specific tuning to a variety of host-

centric as well as peer-to-peer applications.

Figure 2. Fan-in/out Usage

In this example, the PEX 8609 would typically have a 1-lane

upstream port, and as many as 7 downstream ports. The

downstream ports provide x1 PCI Express connectivity to the

endpoints. The figure also shows how some of the ports can be

bridged to provide PCI slots or Generic devices through the

use of the PEX 8311 and PEX 8112 PCIe bridging devices.

The DMA engine in the PEX8609 can alternatively be used

for data transfers between the ASICs, FPGAs and the host.

The integrated DMA engine together with the PEX8609

ability to support direct peer-to-peer transfers can alternately

be used to transfer data between the ASICs and FPGAs in the

system.

Active-Standby Failover Model

The PEX 8609 supports applications requiring host failover

applications through the non-transparency and DMA