MPC8535EBVTANG datasheet(24/126 Pages) FREESCALE

24 / 126 page

MPC8535E PowerQUICC™ III Integrated Processor Hardware Specifications, Rev. 2

Overall DC Electrical Characteristics

Freescale Semiconductor

Figure 2 shows the undershoot and overshoot voltages at the interfaces of the MPC8535E.

Figure 7. Overshoot/Undershoot Voltage for GVDD/OVDD/LVDD

The core voltage must always be provided at nominal 1.0 V (See Table 2 for actual recommended core voltage). Voltage to the

processor interface I/Os are provided through separate sets of supply pins and must be provided at the voltages shown in Table 2.

The input voltage threshold scales with respect to the associated I/O supply voltage. OVDD and LVDD based receivers are simple

CMOS I/O circuits and satisfy appropriate LVCMOS type specifications. The DDR2 and DDR3 SDRAM interface uses

differential receivers referenced by the externally supplied MVREFn signal (nominally set to GVDD/2) as is appropriate for the

SSTL_1.8 electrical signaling standard for DDR2 or 1.5-V electrical signaling for DDR3. The DDR DQS receivers cannot be

operated in single-ended fashion. The complement signal must be properly driven and cannot be grounded.

GND

GND – 0.3 V

GND – 0.7 V

Not to Exceed 10%

B/G/L/OVDD + 20%

B/G/L/OVDD

B/G/L/OVDD + 5%

of tCLOCK

1. tCLOCK refers to the clock period associated with the respective interface:

VIH

VIL

Note:

2. With the PCI overshoot allowed (as specified above), the device

does not fully comply with the maximum AC ratings and device protection

guideline outlined in the PCI rev. 2.2 standard (section 4.2.2.3).

For I2C and JTAG, tCLOCK references SYSCLK.

For DDR, tCLOCK references MCLK.

For eTSEC, tCLOCK references EC_GTX_CLK125.

For eLBC, tCLOCK references LCLK.

For PCI, tCLOCK references PCI1_CLK or SYSCLK.

MPC8535EBVTANG 데이터시트(PDF) 24 Page - Freescale Semiconductor, Inc