6

X24022

Flow 1. ACK Polling Sequence

Page Write

The X24022 is capable of an four byte page write

operation. It is initiated in the same manner as the byte

write operation, but instead of terminating the write cycle

after the first data word is transferred, the master can

transmit up to three more words. After the receipt of each

word, the X24022 will respond with an acknowledge.

After the receipt of each word, the two low order address

bits are internally incremented by one. The high order

five bits of the address remain constant. If the master

should transmit more than four words prior to generating

the stop condition, the address counter will “roll over”

and the previously written data will be overwritten. As

with the byte write operation, all inputs are disabled until

completion of the internal write cycle. Refer to Figure 6

for the address, acknowledge and data transfer

sequence.

Acknowledge Polling

The disabling of the inputs, during the internal write

operation, can be used to take advantage of the typical

5 ms write cycle time. Once the stop condition is issued

to indicate the end of the host’s write operation the

X24022 initiates the internal write cycle. ACK polling can

be initiated immediately. This involves issuing the start

condition followed by the slave address for a write

operation. If the X24022 is still busy with the write

operation no ACK will be returned. If the X24022 has

completed the write operation an ACK will be returned

and the master can then proceed with the next read or

write operation (See Flow 1).

WRITE OPERATION

COMPLETED

ENTER ACK POLLING

ISSUE

START

ISSUE SLAVE

ADDRESS AND R/W = 0

ACK

RETURNED?

NEXT

OPERATION

A WRITE?

ISSUE BYTE

ADDRESS

PROCEED

ISSUE STOP

NO

YES

YES

PROCEED

ISSUE STOP

NO

3848 FHD F11

Figure 6. Page Write

3848 FHD F12

BUS ACTIVITY:

MASTER

SDA LINE

BUS ACTIVITY:

X24022

S

T

A

R

T

SLAVE

ADDRESS

S

S

T

O

P

P

A

C

K

A

C

K

A

C

K

A

C

K

A

C

K

WORD

ADDRESS (n)

DATA n

DATA n+1

DATA n+3

NOTE: In this example n = xxxx 0000(B); x = 1 or 0