| 전자부품 데이터시트 검색엔진 |
|
X88C75PI 데이터시트(PDF) 9 Page - Xicor Inc. |
|
|
|||||||||||||||||||||||||||||
X88C75PI 데이터시트(HTML) 9 Page - Xicor Inc. |
|
9 / 27 page ![]() X88C75 SLIC® E2 9 Interrupt Status Register (ISR) The Interrupt Status Register is a volatile register used to configure the interrupt condition for the I/O ports as well as to determine the interrupt status of the ports. The X88C75 ports can generate an interrupt to the microcon- troller upon the proper transition (as specified in the configuration register) on either STRA or STRB pins when the corresponding I/O port is configured as an input. The INT flag is set when any of the input strobes are toggled provided that their corresponding interrupt en- able bits (ENA, ENB) are set. The INT flag is cleared when latched data is read (PDR) or pending interrupt status flag (INTA, INTB) in ISR is forced to “0” by the interrupt service routine. Interrupt service routine should examine the interrupt status flags (INTA, INTB) and identify the source of pending interrupt. The E2 memory interrupt status flag (EOW) is another means to detect the early completion of a write cycle. When ENEE is enabled, the hardware will set the EOW flag, and interrupt the microcontroller at the end of an internal programming cycle. Toggle Bit Polling can be replaced by this hardware interrupt, which reduces the software overhead. The EOW flag should be cleared by software. The interrupt status register bits are mapped as follows. Figure 10. Interrupt Status Register INT 2887 ILL F14.1 INTA INTB ENA ENB ENEE 0 EOW 76543210 Interrupt Flag “0” = No pending interrupt “1” = Interrupt request Port B – Interrupt Status “0” = No pending interrupt “1” = Port B latched data when a valid transition occurred on the STRB and port B was an input port. Port A – Interrupt Enable “0” = Mask off interrupt “1” = Interrupt enabled Port B – Interrupt Enable “0” = Mask off interrupt “1” = Interrupt enabled EEPROM Interrupt Enable “0” = Mask off interrupt “1” = Interrupt enabled EEPROM Interrupt Status “0” = Programming in progress “1” = Set by hardware when it completes programming the previously written data Port A – Interrupt Status “0” = No pending interrupt “1” = Port A latched data when a valid transition occurred on the STRA and port A was an input port. |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |