MCP4801-ESLASHMS datasheet(19/48 Pages) MICROCHIP

19 / 48 page

 2010 Microchip Technology Inc.

DS22244B-page 19

MCP4801/4811/4821

4.1.3

POWER-ON RESET CIRCUIT

The internal Power-on Reset (POR) circuit monitors the

power

supply

voltage

(VDD) during the device

operation. The circuit also ensures that the DAC

powers up with high output impedance (<SHDN> = 0,

typically 500 k

. The devices will continue to have a

high-impedance output until a valid write command is

received, and the LDAC pin meets the input low

threshold.

If the power supply voltage is less than the POR

threshold (VPOR = 2.0V, typical), the DAC will be held

in the Reset state. It will remain in that state until

VDD >VPOR and a subsequent write command is

received.

Figure 4-3 shows a typical power supply transient

pulse and the duration required to cause a reset to

occur, as well as the relationship between the duration

and trip voltage. A 0.1 µF decoupling capacitor,

mounted as close as possible to the VDD pin, can

provide additional transient immunity.

FIGURE 4-3:

Typical Transient Response.

4.1.4

SHUTDOWN MODE

The user can shut down the device using a software

command (<SHDN> = 0) or SHDN pin. During

shutdown mode, most of the internal circuits, including

the output amplifier, are turned off for power savings.

The internal reference is not affected by the shutdown

command. The serial interface also remains active,

allowing a write command to bring the device out of

Shutdown mode. There will be no analog output at the

VOUT pin, which is internally switched to a known resis-

tive load (500 k

typical. Figure 4-4 shows the analog

output stage during Shutdown mode.

The condition of the Power-on Reset circuit during

Shutdown is as follows:

Turned off if shutdown occurred from the SHDN

Remains turned on if the shutdown occurred

through software

The device will remain in Shutdown mode until the

<SHDN> bit = 1 is latched into the device or SHDN pin

is changed to logic high. When the device is changed

from Shutdown to Active mode, the output settling time

takes < 10 µs, but greater than the standard active

mode settling time (4.5 µs).

FIGURE 4-4:

Output Stage for Shutdown

Mode.

Transients above the curve

will cause a reset

Transients below the curve

will NOT cause a reset

Time

Transient Duration

VPOR

VDD - VPOR

TA = +25°C

VDD - VPOR (V)

500 k



Power-Down

Control Circuit

Resistive

Load

VOUT

Amp

Resistive String DAC

MCP4801-E/MS 데이터시트(PDF) 19 Page - Microchip Technology

MCP4801-E/MS 데이터시트(HTML) 19 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

데이터시트 다운로드

링크 URL