MCP4902-ESLASHST datasheet(23/48 Pages) MICROCHIP

23 / 48 page

 2010 Microchip Technology Inc.

DS22250A-page 23

MCP4902/4912/4922

5.0

SERIAL INTERFACE

5.1

Overview

The MCP4902/4912/4922 devices are designed to

interface directly with the Serial Peripheral Interface

(SPI) port, which is available on many microcontrollers

and supports Mode 0,0 and Mode 1,1. Commands and

data are sent to the device via the SDI pin, with data

being clocked-in on the rising edge of SCK. The

communications are unidirectional, thus the data

cannot be read out of the MCP4902/4912/4922. The

CS pin must be held low for the duration of a write

command. The write command consists of 16 bits and

is used to configure the DAC’s control and data latches.

that is used to configure and load the DACA and DACB

registers for each device. Figure 5-1 to Figure 5-3

show the write command for each device.

Refer to Figure 1-1 and SPI Timing Specifications

Table for detailed input and output timing specifications

for both Mode 0,0 and Mode 1,1 operation.

5.2

Write Command

The write command is initiated by driving the CS pin

low, followed by clocking the four Configuration bits and

the 12 data bits into the SDI pin on the rising edge of

SCK. The CS pin is then raised, causing the data to be

latched into the selected DAC’s input registers. The

MCP4902/4912/4922 utilizes a double-buffered latch

structure to allow both DACA’s and DACB’s outputs to

be synchronized with the LDAC pin, if desired. Upon

the LDAC pin achieving a low state, the values held in

the DAC’s input registers are transferred into the DAC’s

output registers. The outputs will transition to the value

and held in the DACX register.

All writes to the MCP4902/4912/4922 are 16-bit words.

Any clocks past the 16th clock will be ignored. The

Most Significant 4 bits are Configuration bits. The

remaining 12 bits are data bits. No data can be

transferred into the device with CS high. This transfer

will only occur if 16 clocks have been transferred into

the device. If the rising edge of CS occurs prior to that,

shifting of data into the input registers will be aborted.

MCP4902-E/ST 데이터시트(PDF) 23 Page - Microchip Technology

MCP4902-E/ST 데이터시트(HTML) 23 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

데이터시트 다운로드

링크 URL