PIC16F676-ESLASHP datasheet(19/132 Pages) MICROCHIP

19 / 132 page

 2010 Microchip Technology Inc.

DS40039F-page 19

PIC16F630/676

2.3

PCL and PCLATH

The program counter (PC) is 13-bits wide. The low byte

comes from the PCL register, which is a readable and

writable register. The high byte (PC<12:8>) is not

directly readable or writable and comes from PCLATH.

On any Reset, the PC is cleared. Figure 2-3 shows the

two situations for the loading of the PC. The upper

example in Figure 2-3 shows how the PC is loaded on

a write to PCL (PCLATH<4:0>

 PCH). The lower

example in Figure 2-3 shows how the PC is loaded

during a CALL or GOTO instruction (PCLATH<4:3>



PCH).

FIGURE 2-3:

LOADING OF PC IN

DIFFERENT SITUATIONS

2.3.1

COMPUTED GOTO

A computed GOTO is accomplished by adding an offset

to the program counter (ADDWF PCL). When perform-

ing a table read using a computed GOTO method, care

should be exercised if the table location crosses a PCL

memory boundary (each 256-byte block). Refer to the

Application Note “Implementing a Table Read"

(AN556).

2.3.2

STACK

The PIC16F630/676 family has an 8-level x 13-bit wide

hardware stack (see Figure 2-1). The stack space is

not part of either program or data space and the Stack

Pointer is not readable or writable. The PC is PUSHed

onto the stack when a CALL instruction is executed or

an interrupt causes a branch. The stack is POPed in

the event of a RETURN,

RETLW

or a RETFIE

instruction execution. PCLATH is not affected by a

PUSH or POP operation.

The stack operates as a circular buffer. This means that

after the stack has been PUSHed eight times, the ninth

push overwrites the value that was stored from the first

push. The tenth push overwrites the second push (and

so on).

8 7

PCLATH<4:0>

PCLATH

Instruction with

ALU Result

GOTO, CALL

Opcode <10:0>

12 11 10

PCLATH<4:3>

PCH

PCL

PCLATH

PCH

PCL

PCL as

Destination

Note 1: There are no Status bits to indicate Stack

Overflow or Stack Underflow conditions.

2: There are no instructions/mnemonics

called PUSH or POP. These are actions

that occur from the execution of the

CALL,

RETURN,

RETLW

and RETFIE

instructions or the vectoring to an

interrupt address.

PIC16F676-E/P 데이터시트(PDF) 19 Page - Microchip Technology

PIC16F676-E/P 데이터시트(HTML) 19 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL