PIC16F882 datasheet(39/328 Pages) MICROCHIP

39 / 328 page

DS41291F-page 37

PIC16F882/883/884/886/887

2.3

PCL and PCLATH

The Program Counter (PC) is 13 bits wide. The low byte

comes from the PCL register, which is a readable and

writable register. The high byte (PC<12:8>) is not directly

readable or writable and comes from PCLATH. On any

Reset, the PC is cleared. Figure 2-7 shows the two

situations for the loading of the PC. The upper example

in Figure 2-7 shows how the PC is loaded on a write to

PCL (PCLATH<4:0>

→ PCH). The lower example in

Figure 2-7 shows how the PC is loaded during a CALL or

GOTO

instruction (PCLATH<4:3>

→ PCH).

FIGURE 2-7:

LOADING OF PC IN

DIFFERENT SITUATIONS

2.3.1

MODIFYING PCL

Executing any instruction with the PCL register as the

destination

simultaneously

causes

the

Program

Counter PC<12:8> bits (PCH) to be replaced by the

contents of the PCLATH register. This allows the entire

contents of the program counter to be changed by

writing the desired upper 5 bits to the PCLATH register.

When the lower 8 bits are written to the PCL register, all

13 bits of the program counter will change to the values

contained in the PCLATH register and those being

written to the PCL register.

A computed GOTO is accomplished by adding an offset

to the program counter (ADDWF PCL). Care should be

exercised when jumping into a look-up table or

program branch table (computed GOTO) by modifying

the PCL register. Assuming that PCLATH is set to the

table start address, if the table length is greater than

255 instructions or if the lower 8 bits of the memory

address rolls over from 0xFF to 0x00 in the middle of

the table, then PCLATH must be incremented for each

address rollover that occurs between the table

beginning and the target location within the table.

For more information refer to Application Note AN556,

“Implementing a Table Read” (DS00556).

2.3.2

STACK

The PIC16F882/883/884/886/887 devices have an

8-level x 13-bit wide hardware stack (see Figures 2-2

and 2-3). The stack space is not part of either program

or data space and the Stack Pointer is not readable or

writable. The PC is PUSHed onto the stack when a

CALL

instruction is executed or an interrupt causes a

branch. The stack is POPed in the event of a RETURN,

RETLW

or a RETFIE instruction execution. PCLATH is

not affected by a PUSH or POP operation.

The stack operates as a circular buffer. This means that

after the stack has been PUSHed eight times, the ninth

push overwrites the value that was stored from the first

push. The tenth push overwrites the second push (and

so on).

2.4

Indirect Addressing, INDF and

FSR Registers

The INDF register is not a physical register. Addressing

the INDF register will cause indirect addressing.

Indirect addressing is possible by using the INDF

accesses data pointed to by the File Select Register

(FSR). Reading INDF itself indirectly will produce 00h.

Writing to the INDF register indirectly results in a no

operation (although Status bits may be affected). An

effective 9-bit address is obtained by concatenating the

8-bit FSR and the IRP bit of the STATUS register, as

shown in Figure 2-8.

A simple program to clear RAM location 20h-2Fh using

indirect addressing is shown in Example 2-1.

EXAMPLE 2-1:

INDIRECT ADDRESSING

PCLATH<4:0>

PCLATH

Instruction with

ALU Result

GOTO

, CALL

OPCODE<10:0>

11 10

PCLATH<4:3>

PCH

PCL

PCLATH

PCH

PCL

PCL as

Destination

Note 1: There are no Status bits to indicate stack

overflow or stack underflow conditions.

2: There are no instructions/mnemonics

called PUSH or POP. These are actions

that occur from the execution of the

CALL,

RETURN,

RETLW

and RETFIE

instructions

the

vectoring

interrupt address.

MOVLW

0x20

;initialize pointer

MOVWF

FSR

;to RAM

CLRF

INDF

;clear INDF register

INCF

FSR

;inc pointer

BTFSS

FSR,4

;all done?

GOTO

;no clear next

CONTINUE

;yes continue

PIC16F882 데이터시트(PDF) 39 Page - Microchip Technology

PIC16F882 데이터시트(HTML) 39 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL