WLCSP16 datasheet(15/38 Pages) NXP

15 / 38 page

LPC1102

All information provided in this document is subject to legal disclaimers.

Objective data sheet

Rev. 00 — 23 June 2010

15 of 38

NXP Semiconductors

LPC1102

32-bit ARM Cortex-M0 microcontroller

7.15.5 AHBLite

The AHBLite connects the CPU bus of the ARM Cortex-M0 to the flash memory, the main

static RAM, and the Boot ROM.

7.15.6 External interrupt inputs

All GPIO pins can be level or edge sensitive interrupt inputs.

7.15.7 Memory mapping control

The Cortex-M0 incorporates a mechanism that allows remapping the interrupt vector table

to alternate locations in the memory map. This is controlled via the Vector Table Offset

The vector table may be located anywhere within the bottom 1 GB of Cortex-M0 address

space. The vector table must be located on a 128 word (512 byte) boundary.

7.16 Emulation and debugging

Debug functions are integrated into the ARM Cortex-M0. Serial wire debug with four

breakpoints and two watchpoints is supported.

Remark: Care must be taken when using the SPI because the SPI clock SCK and the

serial wire debug clock SWCLK share the same pin on the WLCSP16 package. Once the

SPI is enabled, the serial wire debugger is no longer available.

WLCSP16 데이터시트(PDF) 15 Page - NXP Semiconductors