| 전자부품 데이터시트 검색엔진 |
|
USB-6008 데이터시트(PDF) 3 Page - National Instruments Corporation |
|
|
|||||||||||||||||||||||||||||
USB-6008 데이터시트(HTML) 3 Page - National Instruments Corporation |
|
3 / 5 page ![]() Specifications Typical at 25 °C unless otherwise noted. Analog Input Absolute accuracy, single-ended Absolute accuracy at full scale, differential1 Number of channels............................ 8 single-ended/4 differential Type of ADC ........................................ Successive approximation ADC resolution (bits) Maximum sampling rate (system dependent) Input range, single-ended................... ±10 V Input range, differential...................... ±20, ±10, ±5, ±4, ±2.5, ±2, ±1.25, ±1 V Maximum working voltage ................. ±10 V Overvoltage protection ....................... ±35 V FIFO buffer size ................................... 512 B Timing resolution ................................ 41.67 ns (24 MHz timebase) Timing accuracy .................................. 100 ppm of actual sample rate Input impedance ................................. 144 k Ω Trigger source...................................... Software or external digital trigger System noise....................................... 5 m Vrms (±10 V range) Analog Output Absolute accuracy (no load) ............... 7 mV typical, 36.4 mV maximum at full scale Number of channels............................ 2 Type of DAC ........................................ Successive approximation DAC resolution .................................... 12 bits Maximum update rate ........................ 150 Hz, software-timed 1Input voltages may not exceed the working voltage range. Output range ....................................... 0 to +5 V Output impedance............................... 50 Ω Output current drive............................ 5 mA Power-on state.................................... 0 V Slew rate............................................. 1 V/µs Short-circuit current ............................ 50 mA Digital I/O Number of channels............................ 12 total 8 (P0.<0..7>) 4 (P1.<0..3>) Direction control ................................. Each channel individually programmable as input or output Output driver type USB-6008 ........................................ Open-drain USB-6009 ........................................ Each channel individually programmable as push-pull or open-drain Compatibility ....................................... CMOS, TTL, LVTTL Internal pull-up resistor ...................... 4.7 k Ω to +5 V Power-on state.................................... Input (high impedance) Absolute maximum voltage range...... -0.5 to +5.8 V Digital logic levels Counter Number of counters ............................ 1 Resolution ........................................... 32 bits Counter measurements....................... Edge counting (falling edge) Pull-up resistor .................................... 4.7 k Ω to 5 V Maximum input frequency.................. 5 MHz Minimum high pulse width................. 100 ns Minimum low pulse width.................. 100 ns Input high voltage ............................... 2.0 V Input low voltage ................................ 0.8 V Power available at I/O connector +5 V output (200 mA maximum) ......... +5 V typical +4.85 V minimum +2.5 V output (1 mA maximum) .......... +2.5 V typical +2.5 V output accuracy ....................... 0.25% max Voltage reference temperature drift... 50 ppm/°C max Low-Cost, Bus-Powered Multifunction DAQ for USB – 12- or 14-Bit, up to 48 kS/s, 8 Analog Inputs 3 BUY ONLINE at ni.com or CALL 800 813 3693 (U.S.) Module Differential Single-Ended USB-6008 12 11 USB-6009 14 13 Range Typical at 25 ˚C (mV) Maximum (0 to 55 ˚C) (mV) ±10 14.7 138 Module Maximum Sampling Rate (kS/s) USB-6008 10 USB-6009 48 Level Min Max Units Input low voltage -0.3 0.8 V Input high voltage 2.0 5.8 V Input leakage current – 50 µA Output low voltage (I = 8.5 mA) – 0.8 V Output high voltage (push-pull, I = -8.5 mA) 2.0 3.5 V Output high voltage (open-drain, I = -0.6 mA, nominal) 2.0 5.0 V Output high voltage (open-drain, I = -8.5 mA, with external pull-up resistor) 2.0 – V Range Typical at 25 ˚C (mV) Maximum (0 to 55 ˚C) (mV) ±20 14.7 138 ±10 7.73 84.8 ±5 4.28 58.4 ±4 3.59 53.1 ±2.5 2.56 45.1 ±2 2.21 42.5 ±1.25 1.70 38.9 ±1 1.53 37.5 |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |