TDF8590TH_2

© NXP B.V. 2007. All rights reserved.

Product data sheet

Rev. 02 — 23 April 2007

8 of 30

NXP Semiconductors

TDF8590TH

2

× 80 W SE (4 Ω) or 1 × 160 W BTL (8 Ω) class-D amplifier

6.4.4 Window protection

The WP checks the conditions at the output terminals of the power stage and is activated:

procedure is interrupted and the TDF8590TH waits until the short to the supply lines

has been removed. Because the test is done before enabling the power stages, no

large currents will flow in the event of a short-circuit.

short to one of the supply lines is made, then during restart (after 100 ms) the window

protection will be activated. As a result the amplifier will not start up until the short to

the supply lines is removed.

6.4.5 Supply voltage protections

If the supply voltage drops below

±12.5 V, the UVP circuit is activated and the

TDF8590TH switch-off will be silent and without pop noise. When the supply voltage rises

above

±12.5 V, the TDF8590TH is restarted again after 100 ms.

If the supply voltage exceeds

±33 V the OVP circuit is activated and the power stages will

shut down. It is re-enabled as soon as the supply voltage drops below

±33 V. So in this

case no timer of 100 ms is started. The maximum operating supply voltage is

±29 V and if

the supply voltage is above the maximal allowable voltage of

±34 V (see Section 7), the

TDF8590TH can be damaged, irrespective of an activated OVP. See Section 12.6

“Pumping effects” for more information about the use of the OVP.

the unbalance threshold level, which is expressed as follows:

V

switches off and is restarted again after 100 ms.

protection circuit will be triggered if the unbalance exceeds approximately 6 V.

In Table 4 an overview is given of all protections and the effect on the output signal.

[1]

Amplifier gain will depend on junction temperature and heat sink size.

[2]

Thermal foldback will influence restart timing depending on heat sink size.

Table 4.

Overview protections TDF8590TH

Protection name

Complete shut down Restart directly

Restart every 100 ms

DIAG

TF

N

Y[1]

NN

OTP

Y

Y[2]

N[2]

N

OCP

N[3]

Y[3]

N[3]

Y

WP

Y[4]

YN

Y

UVP

Y

N

Y

N

OVP

Y

Y

N

N

UBP

Y

N

Y

N

V

th unb

()

0.15

V

DDA

V

SSA

–

()

×

≈