ST10F272Z2T3 datasheet(83/189 Pages) STMICROELECTRONICS

부품명	ST10F272Z2T3

상세설명	16-bit MCU with 256 Kbyte Flash memory and 20 Kbyte RAM

PDF	189 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

83 / 189 page

ST10F272Z2

System reset

83/189

sufficient: anyway, a maximum of 100 nF on V18 pin should

not generate problems of over-current (higher value is

allowed if current is limited by the external hardware).

External current limitation is anyway recommended also to

avoid risks of damage in case of temporary short between

V18 and ground: the internal 1.8 V drivers are sized to drive

currents of several tens of Ampere, so the current shall be

limited by the external hardware. The limit of current is

imposed by power dissipation considerations (Refer to

Electrical Characteristics Section).

In next Figures 17 and 18 Asynchronous Power-on timing diagrams are reported,

respectively with boot from internal or external memory, highlighting the reset phase

extension introduced by the embedded FLASH module when selected.

Note:

Never power the device without keeping RSTIN pin grounded: the device could enter in

unpredictable states, risking also permanent damages.

ST10F272Z2T3 데이터시트(PDF) 83 Page - STMicroelectronics