| 전자부품 데이터시트 검색엔진 |
|
IRDC3870 데이터시트(PDF) 2 Page - International Rectifier |
|
|
|||||||||||||||||||||||||||||
IRDC3870 데이터시트(HTML) 2 Page - International Rectifier |
|
2 / 17 page ![]() IRDC3870 2 A well regulated +12V input supply should be connected to VIN and PGND. A maximum 10A load should be connected to VOUT and PGND. The connection diagram is shown in Fig. 1 and inputs and outputs of the board are listed in Table I. IRDC3870 has three input connectors, one for biasing (PVcc),one for biasing Vcc and the third one as input voltage (Vin). Separate supplies should be applied to these inputs. PVcc input should be a well regulated 4.5V-5.5V supply and it would be connected to PVcc and PGND and Vcc input should be a well regulated 3.0V-3.6V supply and it would be connected to Vcc and PGND. An external signal can be provided as Enable signal to turn on or turn off the converter. The absolute maximum voltage of Enable signal is +3.9V. A well regulated 0-2V signal source is used in this user guide. The evaluation board is configured for use with 2x10uF (ceramic 0805) + 1x150uF (SP) capacitors. However, the design can be modified for an all ceramic output cap configuration by adding the inductor DCR sensing circuit as show in the schematic on page 8. CONNECTIONS and OPERATING INSTRUCTIONS LAYOUT The PCB is a 4-layer board. All layers are 2 Oz. copper. The IR3870 and other components are mounted on the top and bottom side of the board. Power supply decoupling capacitors, the Bootstrap capacitor and feedback components are located close to IR3870. The feedback resistors are connected to the output voltage at the point of regulation and are located close to IR3870. To improve efficiency, the circuit board is designed to minimize the length of the on-board power ground current path. Table I. Connections Connection Signal Name VIN (TP53) VIN (+12V) PGND (TP55) Ground of VIN PVcc+ (TP61) PVcc input (+5.0V) Vcc+ (TP59) PVcc input (+3.3V) PGND (TP62) Ground for PVcc input PGND (TP60) Ground for Vcc input PGND (TB6) Ground of V out VOUT (TB5) V out (+1.1V) Enable (TP52) Enable input |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |