| 전자부품 데이터시트 검색엔진 |
|
TLE7243SL 데이터시트(PDF) 18 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
TLE7243SL 데이터시트(HTML) 18 Page - Infineon Technologies AG |
|
18 / 28 page ![]() SPI Driver for Enhanced Relay Control SPIDER - TLE7243SL Diagnosis Features Datasheet 18 Rev. 1.0, 2009-09-30 7 Diagnosis Features The SPI of SPIDER - TLE7243SL provides diagnosis information about the device and about the load. There are following diagnosis flags implemented: The diagnosis information of the protective functions of channel n is latched in the diagnosis flag Dn. The open load diagnosis of channel n is latched in the diagnosis flag OLn. Both flags are cleared by programming the specific channel to Standby (STB). 7.1 Diagnosis Characteristics Note: Characteristics show the deviation of parameter at given supply voltage and junction temperature. Typical values show the typical parameters expected from manufacturing. Failure Mode Comment Open Load or short circuit to ground Diagnosis, when channel n is switched on: none Diagnosis, when channel n is switched off: according to voltage level at the output pin, flag OLn is set after time t d(OL). When the channel is in OFF there is Diagnosis active, in Standby the Diagnosis is not enabled Over Temperature When over temperature occurs, the according diagnosis flag Dn is set. If the affected channel n was active it is switched off. The diagnosis flags are latched until they have been cleared by programming the channel STB. Over Load (Short Circuit) When over load is detected at channel n, the affected channel is switched off after time tOFF(OVL) and the dedicated diagnosis flag Dn is set. The diagnosis flags are latched until they have been cleared by programming the channel STB Electrical Characteristics: Diagnosis All voltages with respect to ground, positive current flowing into pin unless otherwise specified: V DD = 3.0 V to VDDA, VDDA= 4.5V to 5.5V, Tj = -40 °C to +150 °C Pos. Parameter Symbol Limit Values Unit Conditions Min. Typ. Max. OFF State Diagnosis 7.1.1 Open load detection threshold voltage V DS(OL) 1.0 2.5 V 7.1.2 Output pull-down diagnosis current per channel I D(PD) 80 μA V DS = 13.5 V 7.1.3 Open load diagnosis delay time t d(OL) 30 200 μs ON State Diagnosis 7.1.4 Over load detection current I D(OVL) 0.5 0.95 A 7.1.5 Over load detection delay time t OFF(OVL) 350 μs |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |