408-10154

LIGHT-N-LOK Connectors

Rev A

2 of 3

Tyco Electronics Corporation

Figure 3

Wires Bottomed

in Connector

Assembly

3. Pull the wire down through the slot in the

strain– relief. See Figure 4.

Figure 4

4. Rotate the wire 90

°. See Figure 5.

Figure 5

5. Dress the wire 180

° to complete the process.

See Figure 6.

Figure 6

Wires Dressed

in Slots at 180°

6. Apply optional approved flammability rated tape

or clamp to organize the wires. See Figure 7.

Figure 7

Optional Tape or

Clamp May Be

Applied

4. CONNECTOR MATING

Align the polarized mating faces of the connectors,

and push the connectors together. DO NOT force the

connectors to mate. When fully mated, the

connectors must appear bottomed with each other

and flush at the point of engagement. An audible and

tactile “click” will be heard and felt. See Figure 8.