P89LPC9331 datasheet(34/94 Pages) NXP

34 / 94 page

P89LPC9331_9341_9351_9361

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 5 — 10 January 2011

34 of 94

NXP Semiconductors

P89LPC9331/9341/9351/9361

8-bit microcontroller with accelerated two-clock 80C51 core

Each interrupt source can be individually enabled or disabled by setting or clearing a bit in

the interrupt enable registers IEN0 or IEN1. The IEN0 register also contains a global

disable bit, EA, which disables all interrupts.

Each interrupt source can be individually programmed to one of four priority levels by

setting or clearing bits in the interrupt priority registers IP0, IP0H, IP1 and IP1H. An

interrupt service routine in progress can be interrupted by a higher priority interrupt, but

not by another interrupt of the same or lower priority. The highest priority interrupt service

cannot be interrupted by any other interrupt source. If two requests of different priority

levels are pending at the start of an instruction, the request of higher priority level is

serviced.

If requests of the same priority level are pending at the start of an instruction, an internal

polling sequence determines which request is serviced. This is called the arbitration

ranking. Note that the arbitration ranking is only used to resolve pending requests of the

same priority level.

7.15.1 External interrupt inputs

The P89LPC9331/9341/9351/9361 has two external interrupt inputs as well as the

Keypad Interrupt function. The two interrupt inputs are identical to those present on the

standard 80C51 microcontrollers.

These external interrupts can be programmed to be level-triggered or edge-triggered by

setting or clearing bit IT1 or IT0 in Register TCON.

In edge-triggered mode, if successive samples of the INTn pin show a HIGH in one cycle

and a LOW in the next cycle, the interrupt request flag IEn in TCON is set, causing an

interrupt request.

If an external interrupt is enabled when the P89LPC9331/9341/9351/9361 is put into

Power-down or Idle mode, the interrupt will cause the processor to wake-up and resume

operation. Refer to Section 7.18 “Power reduction modes” for details.

P89LPC9331 데이터시트(PDF) 34 Page - NXP Semiconductors