MIC3202 datasheet(13/19 Pages) MICREL

부품명	MIC3202

상세설명	High-Brightness LED Driver with Integrated MOSFET and High-Side Current Sense

PDF	19 Pages

Scroll/Zoom	100%

제조업체	MICREL [Micrel Semiconductor]

홈페이지	http://www.micrel.com

Logo

13 / 19 page

Micrel, Inc.

MIC3202

September 2010

M9999-091710-A

Ripple Measurements

To properly measure ripple on either input or output of a

switching regulator, a proper ring in tip measurement is

required. Standard oscilloscope probes come with a

grounding clip, or a long wire with an alligator clip.

Unfortunately, for high-frequency measurements, this

ground clip can pick-up high-frequency noise and

erroneously inject it into the measured output ripple.

The standard evaluation board accommodates a home

made version by providing probe points for both the

input and output supplies and their respective grounds.

This requires the removing of the oscilloscope probe

sheath and ground clip from a standard oscilloscope

probe and wrapping a non-shielded bus wire around the

oscilloscope probe. If there does not happen to be any

non-shielded bus wire immediately available, the leads

from axial resistors will work. By maintaining the shortest

possible ground lengths on the oscilloscope probe, true

ripple measurements can be obtained.

Figure 2. Low-Noise Measurement

MIC3202 데이터시트(PDF) 13 Page - Micrel Semiconductor