| 전자부품 데이터시트 검색엔진 |
|
ADP2127 데이터시트(PDF) 16 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
ADP2127 데이터시트(HTML) 16 Page - Analog Devices |
|
16 / 20 page ![]() ADP2126/ADP2127 Rev. A | Page 16 of 20 PCB LAYOUT GUIDELINES Figure 31. ADP2126/ADP2127 Recommended Top Layer Layout Figure 32. ADP2126/ADP2127 Recommended Bottom Layer Layout For high efficiency, good regulation, and stability, a well-designed and manufactured PCB is required. Use the following guidelines when designing PCBs: • Keep the low ESR input capacitor, CIN, close to VIN and GND. • Keep high current traces as short and as wide as possible. • Avoid routing high impedance traces near any node connected to SW or near the inductor to prevent radiated noise injection. • Keep the low ESR output capacitor, COUT, close to the FB and GND pins of the ADP2126/ADP2127. Long trace lengths from the part to the output capacitor add series inductance that may cause instability or increased ripple. To ensure package reliability, consider the following guidelines when designing the footprint for the ADP2126/ADP2127. The BUMPED_CHIP device footprint must ultimately be determined according to application and customer specific reliability requirements, PCB fabrication quality, and PCB assembly capabilities. • The Cu pad on the PCB for each solder bump should be 80% to 100% of the width of the solder bump. A smaller pad opening favors solder joint reliability (SJR) performance, whereas a larger pad opening favors drop test performance. The maximum pad size, including tolerance, should not exceed 180 μm. • Electroplated nickel, immersion gold (ENIG) and organic solderability preservative (OSP) were used for internal reliability testing and are recommended. • Nonsolder mask defined (NSMD) Cu pads are recommended for the BUMPED_CHIP package. • The solder mask opening should be approximately 100 μm larger than the pad opening. • The trace width should be less than two-thirds the size of the pad opening. • The routing of traces from the Cu pads should be symmetrical in X and Y directions. Symmetrical routing of the traces prevents part rotation due to uneven solder wetting/surface tension forces. • Stencil design is important for proper transfer of paste onto the Cu pads. Area ratio (AR), the relationship between the surface area of the stencil aperture and the inside surface area of the aperture walls, is critically important. Stencil thickness has the greatest impact on this ratio. AR values from 0.66 to 0.8 provide the best paste transfer efficiency and repeatability. The AR is calculated from Aw Ap AR = where: Ap is the area of the aperture opening. Aw is the wall area. |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |