Data Sheet

14

Rev. 1.0, 2010-02-18

SPI Driver for Enhanced Relay Control

TLE7238SL

Power Supply

During this device condition a read on SPI delivers the Standard Diagnostic Frame with a TER flag, if

V

the under voltage threshold already, if not SPI is not working.

This under voltage reset is released when

V

Reset Command: There is a reset command available to reset all register bits of the register bank and the

diagnosis registers. As soon as CMD.RST = 1, a reset is triggered.

Limp Home Mode: In limp home mode, the SPI write-registers are reset. The SPI interface is operating normally,

so the limp home bit LHI as well as the diagnosis flags can be read, but no command is accepted until the device

leaves the Limp home operation.