PG. 5

SUPERWORLD ELECTRONICS (S) PTE LTD

8. RELIABILITY AND TEST CONDITION

Humidity Resistance

Thermal Shock

Temperature Test

Reliability Test

Measure at room temperature after placing for 2 to 3 hrs.

Humidity : 85± 3% RH

Time : 1000± 12hrs

Temperature : 85± 2° C

3

2

1

Total : 300 cycles

Step

Conditions of 1 cycle.

Room Temperature

+125+2/-0

-40+0/-2

15± 1

15± 1

Temperature (° C)

Times (min.)

Measured at room temperature after placing for 2 to 3hrs

Time : 1000± 12hrs

Temperature : 125± 2° C

Refer to standard electrical characteristics list

PERFORMANCE

Electrical Characteristics Test

Saturation Current (Isat)

Heat Rated Current (Irms)

DCR

Inductance

ITEM

HP4284A, CH11025, CH3302, CH1320, CH1320S

CH16502, Agilent33420A Micro-Ohm Meter.

LCR meter.

TEST CONDITION

Random Vibration

This cycle shall be performed 12 times in each of three

mutually perpendicular directions.

Amplitude: Parts mounted within 2" from any secure point

Frequency : 10-2000-10Hz for 20 min.

Test

(MIL-PRF-27)

(AEC-Q200-REV C)

Temperature : 260± 5° C, 20-40 seconds

Duration : 5 minutes

Preheat : 150± 5° C

Reflow Test

Electric specification should be satisfied

Solder test

After dip into flux dip into solder

235± 5° C, 4± 1seconds

Flux, solder for lead free

(ANSI/J-STD-002C Method B)

Terminals should be covered by over 95%

solder on visual inspection.

2. Temperature measured by digital surface thermometer

1. Applied the allowed DC current(keep 1min).

approximately

T of 40°C without core loss

Irms(A) will cause the coil temperature rise

Isat(A) will cause Lo to drop

Directions and times : X, Y, Z directions for 20 min.

Within <0.2

Measured at room temperature after placing for 2 to 3hrs

(AEC-Q200-REV C)

25.02.2011

(Total 12hours).

(MIL-STD-202 Method 204 D Test condition B)

(IPC/JEDEC J-STD-020C)

MOLDED POWER CHOKE COIL

PIB0502MP SERIES

NOTE : Specifications subject to change without notice. Please check our website for latest information.

L30% typical

Temperature Test

Measured at room temperature after placing for 2 to 3hrs

Time :500± 12hrs

Temperature : -40± 2° C

Low

High

HF

Halogen

Free