SM5K3 datasheet(14/28 Pages) SHARP

14 / 28 page

SM5K3/SM5K4/SM5K5

- 14 -

FUNCTIONAL DESCRIPTION

Hardware Reset Function

Reset function initializes the SM5K3/5K4/5K5

systems. When the input on the RESET pin goes

Low, the system enters reset condition after 2

command cycles. After the RESET pin goes High

level, the reset condition is removed as the input

pulse from OSCIN pin repeats 215 times, forcing the

program counter to start at 0 page and 0 address.

Initialized status of the system immediately after

resetting is shown below.

Reset causes the following changes.

1) I/O pins are set input.

2) All mode registers are reset.

3) Output latch register P0 is reset, causing P00 to

P03 pins go High level.

4) Interrupt request flags (IFA, IFB, and IFT),

interrupt master enable flag (IME) are reset,

disabling all interrupts.

Standby Feature

The standby function saves power by stopping the

program whenever it is not necessary to run. The

mode in which the microcomputer is executing the

program is called the run mode and the mode in

which it stops the program is called the standby

mode. Standby mode is further divided into two

modes : stop mode and halt mode, one of which is

selected by halt instruction or stop instruction. Upon

removal of standby condition, the SM5K3/5K4/5K5

return from the standby mode to the normal run

mode. To enter the standby mode, select either

stop mode or halt mode whichever is appropriate

(Fig. 8).

Table 2

Status of Flags and Registers Immediately after Reset

FLAG REGISTER

STATUS

FLAG REGISTER

STATUS

IFA flag

Level 1

IFB flag

RAM

Undefined

IFT flag

Undefined

IME flag

Undefined

C flag

Undefined

P0, P2, P4, P5 output latch register

BM, BL registers, SB register

Undefined

Timers (RA, RB), divider

R3, R8

∗, R9, RC, RE, RF

∗ The content of the bit R84 is undefined because it is read only.

SM5K3 데이터시트(PDF) 14 Page - Sharp Corporation

SM5K3 데이터시트(HTML) 14 Page - Sharp Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

데이터시트 다운로드

링크 URL