For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824

Phone: 978-250-3343

Fax: 978-250-3373

Order On-line at www.hittite.com

Application Support: Phone: 978-250-3343 or apps@hittite.com

6

6 - 10

Evaluation PCB

List of Materials for

Item

Description

J1 - J4

PC Mount sMA RF Connector

J5 - J6

2mm DC header

C1 - C5, C8 - C10

1000 pF Capacitor, 0402 Pkg

C6 - C7

100 pF Capacitor, 0402 Pkg

C15

1000 pF Capacitor, 0603 Pkg

C16

4.7 μF Tantalum Capacitor Case A

D

LED Green, 0603 Pkg

R1

10k Ohm, Resistor, Array

R8, R9

10k Ohm, Resistor, 0402 Pkg.

R11

1k Ohm, Resistor, 0402 Pkg.

R12

100 Ohm, Resistor, 0402 Pkg.

U1

hMC698LP5(E) synthesizer

116106 Eval Board

[1] Reference this number when ordering complete evaluation PCB

[2] Circuit Board Material: Rogers 4350

The circuit board used in the final application should use RF circuit design techniques. signal lines should have 50

ohm impedance while the package backside ground paddle should be connected directly to the ground plane similar

to that shown. A sufficient number of via holes should be used to connect the top and bottom ground planes. The

evaluation circuit board shown is available from hittite upon request.

Note: The evaluation PCB for the hMC698LP5 contains

10K Ohm pull up resistors for each of the 9 control inputs.

Programming the 251 distinct division ratios consists of

installing or removing jumpers N0 through N5 and s0, s1.

Note: 0 = Jumper Installed.

1 = Jumper Not Installed.

Evaluation PCB Truth Table

(see Programming Truth Table)

HMC698LP5 / 698LP5E

v03.0709

7 GHz INTEGER N SYNTHESIZER

(N = 12 - 259)