UR15033

LINEAR INTEGRATED CIRCUIT

UNISONICTECHNOLOGIESCO.,LTD

5 of 6

www.unisonic.com.tw

QW-R102-019.D

TEST CIRCUIT FOR RIPPLE REJECTION RATIO

GND

Vcc

22µF

Io

+

0.33µF

V

ein

or

APPLICATION INFORMATION

Operation Supply Voltage Range

The circuit functionality is guaranteed within operation of ambient temperature range, as long as it is within

operation supply voltage range. The standard electrical characteristic values are guaranteed at the test circuit

voltage of Vcc=6V. The cannot be guaranteed at other voltages in the operating range of 4.0V ~ 16.0V, homever, the

variation will be small.

For proper regulation, this device must be operated in the Recommended Operating Region shown above.

Power Dissipation

Refer to the thermal duration characteristics shown in Fig.3. Also, be sure to use this IC within a power dissipation

rage allowing enough margins.

Output and Bypass Capacitor

To prevent oscillations, place the output capacitor between the output pin and GND for both channel. There is a

possibility for oscillation if capacitor's value changes due to temperature, voltage, etc. More than 22μF electrolytic

capacitor is recommended. If an extremely large value of (over 1000μF) is used, it may cause oscillations at low

frequency. In case of using ceramic capacitor (it is recommended more than 10μF) connect with 1Ω resistance

recommended.

Over- current Protection Circuit

The over-current protection circuits are built in at the outputs. They protect the IC from being damaged when the

load is short-circuited or subjected to an over current condition. This protection circuits perform holdback current

limiting.