Application information

STGIPN3H60A

12/17

Doc ID 018958 Rev 3

4.1

Recommendations

●

Input signals HIN, LIN are active-high logic. A 500 k

Ω (typ.) pull-down resistor is built-in

for each high side input. If an external RC filter is used for noise immunity, attention

should be given to the variation of the input signal level.

●

To prevent input signal oscillation, the wiring of each input should be as short as

possible.

●

By integrating an application-specific type HVIC inside the module, direct coupling to

the MCU terminals without an opto-coupler is possible.

●

Each capacitor should be located as close as possible to the pins of the IPM.

●

Low inductance shunt resistors should be used for phase leg current sensing.

●

Electrolytic bus capacitors should be mounted as close to the module bus terminals as

possible. Additional high frequency ceramic capacitors mounted close to the module

pins will further improve performance.

Note:

For further details refer to AN4043.

Table 11.

Recommended operating conditions

Symbol

Parameter

Test conditions

Min.

Typ.

Max.

Unit

Supply voltage

Applied between P-Nu, Nv,

Nw

300

500

V

Control supply voltage

GND

12

15

17

V

High side bias voltage

11.5

17

V

Blanking time to prevent

Arm-short

For each input signal

1.5

µs

PWM input signal

25

kHz

Case operation temperature

100

°C