Std datasheet(3/13 Pages) TI1

3 / 13 page

www.ti.com

Getting Started

Figure 1 highlights the user interface items associated with the EVM. The polarized V

IN Power terminal

block is used for connection to the host input supply and the polarized V

OUT Power terminal block is used

for connection to the load. The terminal blocks can except up to 16 AWG wire.

The V

IN monitor and VOUT monitor test points located near the power terminal blocks are intended to be

used as voltage monitoring points where voltmeters can be connected to measure V

IN and VOUT. The

voltmeter references should be connected to any of the four V

IN/VOUT monitor grounds test points located

between the power terminal blocks. Do not use these V

IN and VOUT monitoring test points as the input

supply or output load connection points. The PCB traces connecting to these test points are not designed

to support high currents.

Figure 1. TPS84x10EVM-00x User Interface

SLUU633A

– September 2011 – Revised February 2012

TPS84410EVM-001/TPS84210EVM-002/TPS84610EVM-003, 2-A to 6-A

Integrated Power Solution

Submit Documentation Feedback

Std 데이터시트(PDF) 3 Page - Texas Instruments