STA382BW datasheet(146/172 Pages) STMICROELECTRONICS

146 / 172 page

STA382BW

146/172

Doc ID 022783 Rev 1

7.17

EQ soft volume configuration registers (addr 0x37 - 0x38)

The soft volume update has a fixed rate by default. Using register 0x37 and 0x38 it is

possible to override the default behavior, allowing different volume change rates.

It is also possible to independently define the fade-in (volume is increased) and fade-out

(volume is decreased) rates according to the desired behavior.

Table 162.

Soft volume update enable, increase

When SVUPE = 1 the volume-up rate is defined by the SVUP[4:0] bits according to the

following formula:

volume-up rate = 48 / (N + 1) dB/ms

where N is the SVUP[4:0] value.

Table 163.

Soft volume update enable, decrease

When SVDWE = 1 the volume-down rate is defined by the SVDW[4:0] bits according to the

following formula:

volume-down rate = 48 / (N + 1) dB/ms

where N is the SVDW[4:0] value.

Note:

For volume-down rates greater than 6 dB/msec it is recommended to disable the CPWMEN

bit and ZCE bit in order to avoid any audible pop noise.

Reserved

SVUPE

SVUP[4]

SVUP[3]

SVUP[2]

SVUP[1]

SVUP[0]

Reserved

SVDWE

SVDW4]

SVDW[3]

SVDW[2]

SVDW[1]

SVDW[0]

SVUPE

Mode

When volume is increased, use the default rate

When volume is increased, use the rates defined by SVUP[4:0].

SVDWE

Mode

When volume is decreased, use the default rate

When volume is decreased, use the rates defined by SVDW[4:0].

STA382BW 데이터시트(PDF) 146 Page - STMicroelectronics

STA382BW 데이터시트(HTML) 146 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL