RT8113 datasheet(13/21 Pages) RICHTEK

13 / 21 page

RT8113

DS8113-02 April 2011

www.richtek.com

After VOUT ramps to VBOOT, the RT8113 stays in this state

for 800

μs (tD3) waiting for valid VID code sent by CPU.

After receiving valid VID code, VOUT continues ramping up

or down to the voltage specified by VID code. After VOUT

ramps to VEAP = VDAC

− VADJ, the RT8113 stays in this

state for 1600

μs (tD5) and then asserts PGOOD = high.

The ramping slew rate of tD2 and tD4 is controlled by the

external capacitor connected to SS pin. The voltage of

Figure 3. Circuit for Soft-Start and Dynamic VID

Figure 4. Soft-Start Wave forms

Soft Start

Circuit

VDAC

ISS

EAP

(Error AMP Positive Input)

Soft Start Current (ISS)

is Limited and Variant

VOUT

COMP

ADJ

CSS

RADJ

VCC12

VCC5

9.6V

4.6V

VDAC

PGOOD

tD1

VOUT

VBOOT

tD2

tD3

tD4

tD5

the SS pin will always be VEAP+0.7V, where the mentioned

0.7V is the typical turn-on threshold of an internal power

switch. Before PGOOD = high, the slew rate of VEAP is

limited to 16

μA/CSS. When PGOOD = high, the slew rate

of VEAP is limited to 160

μA/CSS, which is 10 times faster

than soft start slew rate for dynamic VID feature. The soft

start waveform is shown in Figure 4.

RT8113 데이터시트(PDF) 13 Page - Richtek Technology Corporation

RT8113 데이터시트(HTML) 13 Page - Richtek Technology Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

데이터시트 다운로드

링크 URL