PICDEMPIC18 datasheet(21/38 Pages) MICROCHIP

21 / 38 page

Getting Started

DS51721B-page 17

2.4.2

Loading the Program

This section describes how to program the PICDEM PIC18 Explorer Demonstration

Board using the MPLAB® Integrated Development Environment (IDE) and the sample

Hex code on the compact disc in the PICDEM PIC18 Explorer Demonstration Board’s Kit.

2.4.2.1

REPROGRAMMING WITH THE COMPACT DISC SAMPLE CODE

To program the PIC18F8722:

Launch the MPLAB IDE application and select Configure>Select

Device>18F8722.

To start the programmer, select Programmer>Select Programmer> ICD2.

To open the Hex code file, select File>Import>Open and select

CD/Hex/18F8722/Demo8722.hex

Connect the J4 jumper to Main (main controller), as shown in Figure 2-7.

FIGURE 2-7:

J4 JUMPER AND ‘MAIN’ SETTING

Move the S4 switch to PIC MCU, as described in “Using the Board As Is” on

page 10.

To program the PIC18F87J11 on the PIM:

Attach the PIM to the demonstration board.

Move the S4 switch to ICE.

Launch the MPLAB IDE application and select Configure>Select

Device>18F87J11.

To start the programmer, select Programmer>Select Programmer>ICD2.

To open the Hex code file, select File>Import>Open and select

CD/Hex/18F87J11/Demo87J11.hex

Connect the J4 jumper to Main (main controller), as shown in Figure 2-7.

J4 Jumper

Jumper Location

Jumper Setting

USB

Main

Note:

Both steps 1 and 2 are described in “Attaching the PIM” on page 13.

PICDEMPIC18 데이터시트(PDF) 21 Page - Microchip Technology